施工工艺/Construction technology

★本产品以辊涂、刷涂为主；不宜喷涂、刮涂；

★The product mainly adopts roller coating and brush coating; it is not suitable for spraying and scraping;

★本产品经充分搅拌均匀后可直接使用，禁止兑水稀释；

★The product can be directly used after being fully stirred and evenly mixed. It is forbidden to dilute it with water;

★将产品均匀的涂刷在瓷砖或马赛克背面上（湿膜厚度≥30um）→平放、晾干（≥1小时）→待涂膜基本成膜之后→铺贴；

★The product shall be evenly painted on the back of ceramic tile or mosaic (wet film thickness ≥ 30um) → flat and dry (≥ 1 hour) → after the film is basically formed → paving and pasting;

★施工环境温度在5~35℃之间，相对湿度不超过75%。

★The construction environment temperature is between 5 ℃ and 35 ℃, and the relative humidity is not more than 75%.

注意事项/Matters needing attention

★本产品不宜与溶剂类油漆同时施工；

★The product should not be applied with solvent paint at the same time;

★施工人员在施工过程中应做好有效的劳动防护，如沾（溅）到眼睛里或皮肤上应立即用清洁的自来水冲洗干净；如出现过敏等症状，应立即携带本产品合格证或本产品包装罐去就近医院医治；

★The construction personnel shall take effective labor protection during the construction process. If it is stained (splashed) in the eyes or on the skin, they shall immediately wash them with clean tap water; in case of allergy and other symptoms, they shall immediately take the product certificate or the product packaging jar to the nearest hospital for treatment;

★本产品废弃物及包装罐处置方式应符合国家和各级政府部门颁布的法律法规。

★The disposal method of waste and packaging cans of this product shall comply with the laws and regulations issued by the state and government departments at all levels.

储存运输/Storage transport

★储存温度在5~35℃之间，存放于干燥、阴凉处，避免日光曝晒、淋雨、潮湿和冷冻；

★The storage temperature is between 5 ~ 35 ℃, and it should be stored in a dry and cool place to avoid sun exposure, rain, humidity and freezing;

★储存和运输应避免碰撞和过高堆放。

★Avoid collision and over stacking during storage and transportation.

特别提示/Special note

★产品质量执行标准、产品出厂日期及保质期等见《产品合格证》。

★See the product certificate for product quality standards, product delivery date and shelf life.